Back to Blogs
Doors & Entry
November 8, 2026

Glass Door Hardware: Plan the Cut-Outs Before Toughening

By Jinnah Hardware
Glass Door Hardware: Plan the Cut-Outs Before Toughening

For a frameless glass door, choose patch fittings, pivots and lock before sending the panel for toughening. Similar-looking covers do not prove matching glass preparation.

Finalise the glass drawing

Pilkington's Planar specification requires all edgework and holes before toughening. Give the fabricator the chosen fitting's exact glass-preparation drawing; do not copy dimensions from a similar-looking model.

Check the whole assembly

  • Confirm fitting and lock models, approved glass thickness, door action and whether the layout includes a transom or sidelight.
  • Match every hole, notch, edge clearance and pivot to the current system drawing before fabrication.
  • Have the fabricator and installer check the same drawing. Do not drill, grind or enlarge finished toughened glass on site.

dormakaba's patch-fitting instructions show model-specific pivot inserts and orientation; use the chosen system's own sheet. If fixing into a wall, see our hidden-services drilling guide; for framed doors, see our hinge guide.

Sources: Pilkington Planar NBS H13 (Nov 2019 version); dormakaba ARCOS (10 May 2026). Accessed 8 November 2026.

Looking for matching hardware?

Explore our curated selection of door fittings, locks, and architectural hardware.

Share this article:
More Articles